compression-pipe-fitting
Filter by:
Source
State or Territory
Back
compression pipe fitting
HB50
fitting in which the seal is achieved by compression of one or more members
See Figure A.68
See also: compression pipe fitting <manipulative>; compression pipe fitting <non-manipulative>
See Figure A.68
See also: compression pipe fitting <manipulative>; compression pipe fitting <non-manipulative>
HB50
<manipulative> fitting in which the joint is made by flaring, croxing, capping or beading the end of the tube which is then compressed by the coupling nut against the shaped end of the corresponding section in the fitting
<non-manipulative> fitting for a compression joint which does not require any working of the tube other than cutting square
<non-manipulative> fitting for a compression joint which does not require any working of the tube other than cutting square
The joint is made tight by means of a loose compression ring which grips the outside wall of the tube when the coupling nut is tightened.